Vredevoogd Heating & Cooling Grand Rapids values each and every customer. Servicing or installing your HVAC system means establishing a service relationship with each homeowner. We promise to earn your trust with our consummate level of professionalism and expert service. We back our work with the strongest industry guarantees because we value your continued business.
Customer stated their blower fan is consistently running. She has had the furnace off all summer and just fired it up and it will just blow consistently. Upon investigation, the technician found that the damper control was sending 24V to G terminal while switched off. This indicates a stuck closed relay. I disconnected it and tested the unit. Due to age of unit, I would recommend upgrading to a more efficient model.
Gerardo was very professional and kept us informed of what he was doing and what was needed. Our house is now the warmest it has been since we purchased it 3 years ago! And all of this was done on a Saturday morning with below freezing temps! We are very thankful and will be using Gerardo of True Comfort again when have the money to replace the furnace altogether.
Heat pumps act like an air conditioner in the summer, removing the heat from the air and then recirculating the cooled air throughout your home. In the winter, though, they can transfer ambient heat from outside into your house, efficiently warming your home with minimal energy consumption. If you do decide on a heat pump in Seattle, WA, make sure that you schedule your installation, maintenance and repair services with a skilled, qualified technician.
Furnace replacement in Denver is necessary if your furnace is broken beyond repair or if it is more than 15 years old. Old furnaces are very inefficient (they use more power and gas than newer ones) and they can even be very hazardous to your health and home. Furnaces are controlled fires, and when the control systems for said fires are out of date or malfunctioning, the safety and wellbeing of your home are in jeopardy. So if you have an old or malfunctioning heater, then give our furnace replacement company a call today.
Next check and clean the furnace’s flame sensor. The video below shows you how—note that this guy fixes it in about 5 minutes. We would probably use a little bit of emory paper, but he cleans the sensor with a 5-dollar bill. Another video further down the page under the discussion of “If your furnace keeps shutting off after about 5 minutes” shows the same project with a different brand of furnace.
While repair is often the preferred choice, problems like a consistent repeating complication or extra-costly furnace repair parts might start leading you in a different direction. Remember that repair is only the preferred option when the cost of seeking it makes sense! If you’re shelling out for repair every single year, then it might be time to talk to your heating contractor about furnace replacement.
Furnaces and thermostats are not mix-and-match appliances. Using the wrong type of thermostat with a furnace will cause operating problems and can be dangerous. Although thermostats look similar, they are designed very differently. There are numerous types of heating systems and thermostat systems and they need to be coordinated for safe and proper operation. There are three types of thermostat systems used today: millivoltage, low voltage, and line voltage.