We have done furnace services numerous times for last 10+ years. All that this technician did was to vacuum inside the furnace, asked me to turn on and turn off furnace, and said it is working fine. He didn't clean the burners, didn't check heating effectiveness, didn't check / change the filter ... Total rip off. I am calling amazon customer service.

If your home is not heated using forced air, chances are a boiler will make sure you stay warm during cold nights. A hot water system delivers hot water through a network of pipes that run to every room in your house. The heating effect gets maximized through radiators. The most common issues with hot water heating tend to be not be major, but small problems that add up over time. Mineral deposits within the water tank, a pilot light malfunction, or an issue with a radiator itself can require professional repair. On average, you will pay between $183 and $582 for these problems. The exact amount will depend on the exact problem, as described in our boiler repair cost guide.

The heating installation process must be completed by a professional heating technician. There is simply no other way to make sure that your furnace is correctly integrated into the home. We take care of every detail, from the gas piping for the furnace to the ducts placed behind walls and in ceilings. Give us a call today to find out more about our Federal Way heating installation service.


Walter was stupendous! He installed a new high-efficiency central air and furnace in my house. His master craftsmanship (artistry) and customer service are in a class of their own. From removing the old unit to all of the finishing touches, testing and review of operating the system, every detail was done in excess of what I could have imagine and I'm a Building Inspector. It was a very pleasant experience for me with only good surprises.
Next check and clean the furnace’s flame sensor. The video below shows you how—note that this guy fixes it in about 5 minutes. We would probably use a little bit of emory paper, but he cleans the sensor with a 5-dollar bill. Another video further down the page under the discussion of “If your furnace keeps shutting off after about 5 minutes” shows the same project with a different brand of furnace.
If your thermostat has a small lever that moves along a calibrated scale that indicates “longer” (not the heat temperature lever), you can try adjusting this—the heat anticipator. Just set it one calibration mark closer to the “longer” setting if the furnace goes off and on too frequently or one mark away if the furnace allows room temperature to rise too high or drop too low before going on or off. It may take several hours for the thermostat to stabilize at this setting, so wait a while and then adjust it again if necessary.
If you have a heating or cooling emergency, call Vredevoogd Heating & Cooling Grand Rapids MI, Furnace Repair Lansing, Furnace Repair Kalamazoo and more at 616-828-5411. When you call you speak directly with one of our service representatives about the problem you are experiencing and schedule a service appointment. Naturally, we prioritize emergencies so you can count on us when your heating or cooling systems fail. After regular business hours, you can reach our customer service staff who will report your problem to on-call technicians. You can expect to hear back from a certified tech within 15 minutes of your call. Your heating and cooling emergency is important to us. We will visit your home ASAP to provide you with the superior service you’d expect from a Furnace Repair, Air Conditioning, AC Repair & HVAC leader like Vredevoogd Heating & Cooling Grand Rapids, AC Repair Lansing, AC Repair Kalamazoo.
When is water heater replacement necessary? If your system breaks down irreparably without any hope for repair, then it’s fairly obvious what needs to be done. But there are other reasons for considering water heater replacement in Federal Way, WA as well. For example, you may want to consider replacing your old model if it no longer works efficiently or effectively, even if it still runs.
Among the leading ways to prevent a breakdown and make sure it runs like a lean machine is with yearly scheduled tune-ups on your furnace. Just like any mechanical equipment, the useful life of a furnace will be enhanced with preventive maintenance, by ensuring that all the elements of the unit are running efficiently. In addition, regular cleanings can help pinpoint concerns before they become big problems and you end up paying emergency rates on a cold winter night. Plus, because furnaces burn fuel to make it hot, it’s important to inspect all the various pieces to ensure there aren’t any ruptures or leaks that could impact the safety of your family. Taking the time to schedule a tune-up, even when it’s not making that odd rattling noise you’ve been ignoring, will save you time, stress, and money throughout the heating season.
Simply put, we put ourselves into our customers shoes and understand that these assurances do more than provide financial protection- they provide peace of mind. Our success is completely dependent on the satisfaction of our customers, so we're willing to do whatever it takes to complete the job to your satisfaction and show you why we're the most trusted when it comes to Plumbing, Heating, Air Conditioning & HVAC in Denver, Colorado!
An electric furnace provides warmth by moving air over and through a series of coils. Ductwork and vents then distribute that air to the individual rooms in your home. Repair costs will depend on both the brand and the exact nature of the problem, but tend to be lower than some of the options above. That's because the units are small, and issues tend to be contained within the heating elements themselves. Expect to spend less than $300 on your electric furnace repair, depending on the exact problem.
There may come a time when air conditioning repair is not enough. If you find that your air conditioner breaks down irreparably, then you may need to opt for air conditioning replacement service. At Bob’s Heating & Air Conditioning, our Federal Way air conditioning replacement technicians can make certain that you make an informed decision about the status of your AC, whether you have a heat pump or central AC.
Natural gas furnaces operate similarly to the above, using a pilot light to ignite the burners and heat up the air. Also similar to propane gas, your average repair costs for a natural gas furnace will range anywhere from $125 for small repairs to $1,200 if you have to replace the entire heat exchanger. The difference between both options is not necessarily the actual furnace, but the type of gas used to burn through it and heat your home. As a result, the repair costs tend to be close to identical.
A whole–house air conditioning system in Federal Way, WA is by no means a luxury, but a necessity. At Bob’s Heating & Air Conditioning, our Federal Way air conditioning system specialists work with customers to ensure that their homes are comfortable all summer long. There is simply no other way to ensure that you and your family are cool during the summer than by having your cooling system service completed by a professional Federal Way air conditioning technician.

As Idaho’s HVAC comfort and zoning specialists, Ultimate Heating & Air handles all of your residential heating, cooling, and air quality requirements.  For every project, we target energy efficiency and reliability of your essential equipment, trimming cost of operation and ownership, while optimizing comfort.  Through industry-leading innovations in both products and strategies, we simplify the challenges of everyday life, put you in superior control over your indoor environment, and promote sustainable solutions.


A-TEMP has been serving the residential heating and air conditioning needs of greater Portland-area homeowners for almost 50 years. We are all about home comfort, just right. So we know how to keep you comfortable all year-round with responsive service, quality products, and well-trained, certified technicians. We offer efficient, best-of-class choices in furnaces, heat pumps, central air conditioning, duct cleaning, service contracts, and more.
If your furnace’s motor runs but the blower doesn’t move air, the belt that connects the two probably has broken. Replacing it is an easy fix. First, turn off all power to the unit and turn off the gas at the gas valve that serves the furnace. Remove the door on the front of the furnace cabinet to give you access to the blower (it might be on a slide-out drawer.) Check the number stamped on the belt and get an exact replacement from a home center or heating supply outlet.
Customer stated their blower fan is consistently running. She has had the furnace off all summer and just fired it up and it will just blow consistently. Upon investigation, the technician found that the damper control was sending 24V to G terminal while switched off. This indicates a stuck closed relay. I disconnected it and tested the unit. Due to age of unit, I would recommend upgrading to a more efficient model.
Ruud, Trane, and American Standard are among the more reliable natural gas furnace brands, whereas Goodman, Lennox, and Amana are among the less reliable brands. York, however, stands out as the least reliable brand and cannot be recommended by Consumer Reports at this time. That’s what we found based on the feedback of 21,618 subscribers, who reported on their experiences with gas furnaces installed between 2011 and 2016.
While repair is often the preferred choice, problems like a consistent repeating complication or extra-costly furnace repair parts might start leading you in a different direction. Remember that repair is only the preferred option when the cost of seeking it makes sense! If you’re shelling out for repair every single year, then it might be time to talk to your heating contractor about furnace replacement.

Sometimes a heating and air conditioning system just needs to be repaired rather than completely replaced. You may need air conditioning repair services if there is leaking around the outside unit, the air coming into the house isn't hot or cool enough, the unit is short-cycling or constantly turning on and off, using the system is consistently resulting in higher-than-normal energy bills, or if there is excessive noise during startup and operation.
Customer stated their blower fan is consistently running. She has had the furnace off all summer and just fired it up and it will just blow consistently. Upon investigation, the technician found that the damper control was sending 24V to G terminal while switched off. This indicates a stuck closed relay. I disconnected it and tested the unit. Due to age of unit, I would recommend upgrading to a more efficient model.
What does air conditioning maintenance mean? Well, it means much more than just changing the air filter. Over time, its internal components may accumulate a substantial amount of dust and other debris that can begin to take its toll on system performance and energy efficiency. Let us take care of your cooling system with our air conditioning maintenance in Federal Way, WA.

We live in a recently completed townhouse that was built with double-wall construction. That construction method was touted by the builder as what would keep sound from penetrating between the units. But we can hear the next door neighbors' TV and stereo, and sometimes voices and even snoring, through the wall. While sometimes it's the volume, mostly it's the bass sounds coming through the wall. They say they don't hear us, but we keep our bass turned down. They crank up the bass, and they are not going to change that. They also are not going to do anything construction-wise to help from their side. What is the best way for us to try to block the low frequency/bass sounds from penetrating the existing wall into our side?
In addition to our gas and electric furnace installation, our Federal Way furnace technicians also make certain that your existing furnace works well for years to come with our furnace repair and maintenance services. Whether your furnace has broken down and no longer functions effectively, or you want to stave off problems by having it routinely maintained, we can help.
Your heating and air conditioning system naturally loses energy efficiency over time. This loss of efficiency is due to many factors, including dust and dirt, natural wear and tear, and buildup in drains or on burners. Keeping your heating system maintained with regular professional tune-ups can help to reduce these factors. During your tune-up, your maintenance technician will clean and check over your heating equipment, identifying areas of wear and tear. They can identify failing parts in need of replacement before they become a serious problem. A tune-up alone may instantly improve energy efficiency by up to 30%. You’ll also enjoy cleaner air and a cleaner residence because your HVAC system will be distributing clean air through a clean air filter. Perhaps one of the greatest benefits you’ll enjoy following a fall furnace or AC tune-up is decreased utility bills. A neglected HVAC system must work much harder to heat and cool your home, while a furnace or air conditioner that has been finely tuned can take less energy to maintain indoor comfort. Because your heating system will function more efficiently, it will deliver superior heating at lower cost than you otherwise may have had through the winter season.

I'm so impressed and happy that I called Affordable Furnace Repair!  Not only did they come out same day, but they were early and quick.  They even showed me how I can try to fix it myself next time.  And they were so nice and friendly!  Sometimes it's weird to invite people into your home to work on something, but this wasn't weird or awkward to me.  I feel like I'm gushing here, but I'm so happy our heat is working again so quickly!

Sky Heating & Air Conditioning provides a wide range of quality HVAC services to homeowners across Portland and The Dalles.  By bringing together skilled technicians and premier products, we deliver superior value for your investment.  We utilize tried and true strategies to enhance efficiency, comfort, and convenience throughout your home.  For heating and air conditioning installation, repair, and regular maintenance, no one takes better care of you than Sky Heating & Air Conditioning.  And we’re always here!  Count on us 24 hours a day, 7 days a week, to protect your safety, comfort, and best interests.


So the furnace went out (again). We’re probably not the people you want to be dialing, but in these circumstances, Service Experts Heating & Air Conditioning in North America should be your very first call. You don’t even have to worry how late (or early) it is – our NATE-certified technicians available at all hours, every day of the year. We’ll be there in a jiffy and get the job done fast – so you can get back to your routine and not have to even think about needing another furnace repair anytime soon.
When your gas furnace isn’t blowing hot air, the issue could be due to a faulty pilot light or broken ignitor. Remove the furnace cover panel and visually inspect whether you can see a flame from the pilot light. A natural gas furnace will be blue and yellow in color, and a propane furnace should have a bluish green flame with a yellow tip. If you can see a flame and it appears normal, the issue could be related to the furnace blower motor or other complex furnace parts. If the flame appears low or non-existent, it’s best to contact an experienced furnace repair company. Remember to never touch any open wires; contact a professional.

I really appreciated the great same-day service provided by Chris H, Swan Plumbing & Heating's technician today. I made an appointment to get an estimate on the water heater replacement, and expected to make another appointment for the installation. But Chris came prepared with all the equipment needed, and replaced our leaking water heater in a very efficient manner within about 2 hours.
The quality of your heating installation can greatly impact the quality of your overall heating experience. If your system is not carefully selected, sized and installed, there is really just no way that you can hope for it to operate at peak performance and efficiency levels. Never settle for a subpar heating installation when our Seattle heating installation technicians are available to do the job right.
Does your water heater make a loud or strange sound during operation? Are you sick and tired of unreasonably high energy bills? Are you out of hot water? Let us take a look at your water heater so that we can take care of any problems that may arise with its operation. Our water heater repair services in Federal Way, WA are thorough and comprehensive.

Having a company take care of all your heating and cooling needs shouldn’t indicate that you’re stuck with any ordinary shop who cuts corners. Heating and cooling has been our excitement since 1967, and it’s apparent in the work we offer to our customers. We’re committed to offering you the very best when it comes to all things HVAC, whether it’s service, maintenance or heating and cooling systems.
We are committed to providing you with services that are effective and efficient. We do the job right the first time, but more importantly, we won't charge our customer when we didn’t fix it the first time. For almost 30 years, we have been providing our customers with work from industry-certified technicians. Our team has the skill and knowledge to get the job done right the first time out!
You can usually slip the belt on the motor’s (smaller) pulley first and then start it on the blower pulley. Rotate the blower pulley by hand, holding the belt in place but keeping your fingers from getting caught between the belt and the pulley. The belt should slip right into place. If it seems to be too tight or difficult to set in place, it may be necessary to adjust the motor mount to provide more slack.
×