Of the various contractors and HVAC service companies, why should you choose AQS for air conditioning and furnace repair? Our company is a family-owned and operated business that has been in business since 1996. It goes without saying that we are extremely experienced in the installation and repair of heating and cooling units. We are proud of our A+ rating from the BBB, and we have received numerous Super Service Awards from Angie's List, both in recognition of the quality services we provide.
You can usually slip the belt on the motor’s (smaller) pulley first and then start it on the blower pulley. Rotate the blower pulley by hand, holding the belt in place but keeping your fingers from getting caught between the belt and the pulley. The belt should slip right into place. If it seems to be too tight or difficult to set in place, it may be necessary to adjust the motor mount to provide more slack.
Heat pumps that wring heat from outdoor air (and reverse the process in summer to act as an air conditioner) are inexpensive to install as an alternative to a cooling-only air-conditioning system. That makes them the preferred way to heat in the South and Southwest, where winters are typically short and mild. Heat pumps that wring heat from the ground are much more expensive to install, but they are suitable for cold climates because they can maintain their operating efficiency. Other inexpensive electric-heat options include strip heaters, which are installed in the ductwork of central air conditioning, and permanently installed baseboard units in each room. But before you consider any type of electric central heating in colder regions, keep in mind that electricity rates are much higher than those for natural gas and are likely to remain that way for the foreseeable future. You can get rate information for various fuels from local utilities and suppliers.
As a Carrier Factory Authorized Dealer, Edwards Heating & Air meets strict requirements for business practices, such as proper licenses, insurance and liability coverage, and customer service.  Our technicians participate in continued factory training, keeping current with advancements in techniques and technology, and adhere to strict installation and maintenance procedures.  Our sales team is educated in leading-edge Carrier products, ensuring accurate recommendations for cost-effective, highly efficient, and reliable solutions to your specific circumstances.  We specialize in heating, cooling, and air quality systems that are widely regarded as the world’s best.  Leading the industry in design and engineering, Carrier products offer unprecedented convenience, economy, and luxury.  These systems don’t just regulate temperature.  They improve your everyday life.
Vredevoogd Heating & Cooling Grand Rapids MI routinely serves the areas of Grand Rapids, Wyoming, Lansing, Grandville, and Kalamazoo. We provide a comprehensive menu of HVAC services delivered by certified HVAC technicians who specialize in heating and cooling repair and installation. World-class customer service is a cornerstone of our business and we are committed to doing the job right the first time. We have a reputation for integrity and service excellence. By living up to our good name, we continue to build our customer base throughout the Michigan region and look forward to adding you to our service family. So if you are looking for a “heating & air company near me” in Grand Rapids, or a Furnace Repair Lansing, Furnace Repair Kalamazoo and more. Call today.
Edwards Heating & Air continues to look for new ways to improve service.  We hire only NATE-certified, extensively experienced, and dedicated professionals.  We offer a wide range of products, from ductless options to heat pumps, furnaces, air conditioners, and air quality systems, guaranteed to answer the most challenging comfort demands.  To maintain your equipment in peak condition, promoting year after year of uninterrupted performance, we offer preventative service plans that are affordable, convenient, and effective.  If you are ever confronted with a malfunction, the team from Edwards Heating & Air is always available, 24 hours a day, 7 days a week, to provide the skilled assistance you need. Through our relationship with Wells Fargo Financial National Bank, we offer flexible financing options with approved credit to facilitate your investment into superior quality heating and cooling.  Our ongoing dedication to your complete satisfaction is evidenced by our complaint-free, A+ rating by the Better Business Bureau.  At Edwards Heating & Air, we do things right, every time.

©2018 By Horizon Services, LLC. All Rights Reserved. DE License # PL0000726, HL0000299. Contractor Reg. # PA017876, PA057742. NJ Plumbing Lic. # PL36BI01232300 - David Geiger HIC reg. # 13VH05117300, NJ Master HVACR contractor Lic. # 19HC00193700. MD Master HVACR contractor Lic. # 47186, MD Master Plumber/Gas Fitter Lic. # 63739 – David Geiger. EL.LIC./B.P. #34EI01207700.


The cost to replace your gas furnace will vary based on the type and size of furnace you select, labor and installation costs, and any repairs your HVAC system may need. Nationally, average HVAC prices for a heating specialist range between $1,800 and $2,500. It’s important to select the right size gas furnace for your heating needs. A furnace that’s too small won’t heat your house properly, while a furnace that’s too large will run inefficiently, cycling on and off and likely breaking down sooner. HVAC specialists calculate your exact heat needs by measuring your home and incorporating variables such as the regional climate and your home’s level of insulation. Retail pricing for gas furnaces can range from $650 up to $3,000 and more. The higher the AFUE (annual fuel utilization efficiency) rating of the furnace, the more efficient it is at turning fuel into heat and the lower your carbon footprint and utility bill will be. HVAC installation costs are often based on an hourly rate and can range from under $50 to over $100 per hour, depending on the company and the furnace being installed. Higher-end furnaces cost more to install because they require added labor and expertise. For a typical installation, it might take two HVAC installation pros one day or less to remove your old furnace and replace it with a new one.
I met the owner while looking at a new house, he was servicing the furnace. I asked for a card and explained that I live in a townhome, he said not a problem. Well I called a day or so late to schedule an appointment. That went smooth due to the season the schedule was 3-4 weeks out. I understand and wait patiently. Week the day before the scheduled service i got a reminder call, those are helpful. Well the gal on the phone calls back a few minutes later she called back and came up with a few excuses on why they can no longer come look at my furnace. They seemed pretty hollow to me and she took a fairly snippy attitude with me as well. Due to hire this went down and the fact that it took a month for them to say no can do, I will never ever pay a positive wire forward towards this company!
Heat exchangers are the components that draw heat from the burned gas. To draw more heat from the air they burn, energy-efficient furnaces supplement the primary exchanger with a second exchanger. Because the exhaust gases in that second exchanger might yield a corrosive acidic condensate, the second exchanger is made of stainless steel, lined with plastic, or otherwise protected.
Moncrief provides a wide range of services from high-quality energy-efficient systems, tune-ups and inspections, as well as repairs in the Roswell and Marietta areas. As a full-service heating and cooling company, we stay up-to-date on the most economical and energy-efficient systems available for your home or business. In addition, our technicians are well-trained in a wide range of systems to provide quality and cost-efficient furnace service, repairs and installation.
A number of other variables can influence your decision on whether to repair or replace your furnace, as well. In addition to cost and brand, consider the expected lifetime of your furnace. If it is more than 15 years old, it might make more sense to invest in a new unit even if it costs more than simply repairing the current problem. Long-term costs also play into the equation. For example, your new furnace may be more energy efficient than the current unit. Even though you will pay more for the actual installation, you might be able to make back your investment through lower energy bills. To make your decision, consult with a reliable professional on what to do. In inspecting your furnace, they will be able to make an informed recommendation that looks not just to the next year, but years into the future. That way, you can make the best possible decision for your home and budget long-term.
Bonney’s NATE certified technicians will troubleshoot and repair your furnace for safe and reliable operation. Our technicians use state of the art tools including video inspection cameras and exhaust gas analyzers to perform thorough, comprehensive diagnostics when equipment is broken. Furthermore, we arrive in a “warehouse on wheels” stocked with many parts to get your furnace repaired as quickly as possible.  For an unexpected heater repair Bonney offers financing to make your comfort affordable.
×