Efficient operation is a function of regular heating system maintenance. When a heating system malfunctions, any one of its three components – heat/cold source, distribution system, or the thermostat  – can be causing the problem. Our technicians can easily detect an impending issue before you have to replace a heating unit or spend a lot of money on parts and labor.
Furnace replacement in Denver is necessary if your furnace is broken beyond repair or if it is more than 15 years old. Old furnaces are very inefficient (they use more power and gas than newer ones) and they can even be very hazardous to your health and home. Furnaces are controlled fires, and when the control systems for said fires are out of date or malfunctioning, the safety and wellbeing of your home are in jeopardy. So if you have an old or malfunctioning heater, then give our furnace replacement company a call today.
AQS is all about offering clients the best possible value. We honor manufacturer warranties for any equipment you purchase from us. Moreover, we provide workmanship warranties for our maintenance services because we want you to be extremely satisfied not only with your heating and cooling units, but with our level of service as well. Allow us to be your partner in maintaining your systems; we will not disappoint you.
Start with your utility company; they can help a great deal. Comparing previous bills isn't always a good measure, as the weather is never exactly the same month to month. Instead, if you take your energy bill and divide it by the square footage of livable space in your home, don't count areas like unfinished garages or basements -- you can calculate how much you are spending to heat or cool each square foot of your home. Your energy provider can tell you what the average cost per square foot is in your region for that same period of time so you can compare apples to apples.
I have a Bosch condenser dryer that heats up and after 3-5 mins cuts out (no lights/power). After is cools a while, the machine can be restarted and runs a while longer until it shuts down again. This process repeats several times, with each progressive drying cycle being a little longer than the previous until the clothes are eventually dry.I've tested the the thermal-protector for continuity and the NTC-sensor on the heating element appears to be fine (tested for resistance). Could it be a faulty sensor/component on the control board that's getting too hot and cutting out the power? And if so, can it be easily identified/replaced, or would I need to replace the whole control board?Any help would be greatly appreciated!
Cleaning the debris that builds up on your filters will aid with the flow of air. When your air filter is clogged, your air handler must work harder to compensate for the blockage of air flow. In addition to driving up your utility bill, the reduced air flow through your heating and cooling system can cause your heat exchanger to overheat and shut off too quickly.    
×