Read what our many satisfied customers say about Moncrief. We consistently receive 5-star reviews from both our commercial and residential customers. Moncrief's legacy of comfort and trust, as well as our great team and customer service are second to none. Contact us today to schedule an appointment or inquire about our Total Comfort Service Plan. Moncrief Heating & Air Conditioning is the company to provide the services you need in Roswell and Marietta. Call us at 404-350-2300.
Don has earned a lifetime customer! My wife and I moved into our fixer-upper house this summer and just when the weather turned we realized that the 8 year old Goodman furnace in our basement had rusted heat exchange pipes and was leaking carbon monoxide. (So much for the $400 I paid to an home inspector before we moved in...) Fortunately, the furnace had a warranty still active. Not so fortunately, Goodman was incompetent in getting us the replacement part. It took them a month to send it, and then it wasn't even the right part. Don went to bat for us and convinced Goodman to foot the bill for an entirely new furnace! He and another worker made time in their busy schedule during thanksgiving week to come out and get the unit installed. This is above and beyond service and I couldn't be happier.

In this video I show you a few things to look for to fix your furnace. It's expensive to call a repair man and most of the time is not needed. I am not an expert, just someone trying to share my experience with you to save some money. Always turn your power to your furnace off before tampering with things. This would be a good video to start with because I try to show a general idea of how a furnace works. When all else fails, you have to call an expert, but first try the steps in this video.

Next check and clean the furnace’s flame sensor. The video below shows you how—note that this guy fixes it in about 5 minutes. We would probably use a little bit of emory paper, but he cleans the sensor with a 5-dollar bill. Another video further down the page under the discussion of “If your furnace keeps shutting off after about 5 minutes” shows the same project with a different brand of furnace.
By combining immediate results with sustainable performance, we protect the value of your investment.  We provide skilled installation, maintenance, and repair of gas furnaces, heat pumps, dual fuel systems, boilers, air conditioners, air quality products, traditional and tankless water heaters, and advanced duct cleaning services.  Welzig Heating & Air is the right choice for  the comfort, safety, and health of homes or offices across Boulder, Longmont, Louisville, Lafayette, CO & more.
When our Denver heating company provides you with maintenance checks before the cold of winter sets in, you will be saving money in several different ways. One of the benefits of a maintenance plan is our technicians will be less likely to have to make repairs throughout the year as long as the system is properly maintained. Our Denver heating company will have your system running at its most efficient, helping to reduce your utility bills each month. An added benefit of a more efficiently running system is the positive environmental effect that it will have.
If your thermostat has a small lever that moves along a calibrated scale that indicates “longer” (not the heat temperature lever), you can try adjusting this—the heat anticipator. Just set it one calibration mark closer to the “longer” setting if the furnace goes off and on too frequently or one mark away if the furnace allows room temperature to rise too high or drop too low before going on or off. It may take several hours for the thermostat to stabilize at this setting, so wait a while and then adjust it again if necessary.
Our technicians have experience repairing furnaces and will make sure your home is back to keeping your family cozy in no time. From training and certifications to our reputation for doing the job right time and time again, you can trust that James Heating & A/C, Inc’s furnace repair technicians will have your troubles taken care of and your furnace operating smoothly. Whether it’s emergency furnace repair or service you can schedule a little in advance, our team can give you peace of mind, knowing that your furnace is in good hands. Are you in need of a furnace repair? When performing a repair, it's important to hire professional HVAC contractors.
Lennox is another leading manufacturer and marketer of gas central furnaces. Lennox central furnaces are available in single and multistage configurations, with some models capable of an AFUE rating of more than 90 percent. Lennox markets units that meet Energy Star requirements and makes others that it claims offer quiet operation. The average price of a Lennox central gas furnace is about $2,500 and Lennoxes are sold through their dealer network.

Don has earned a lifetime customer! My wife and I moved into our fixer-upper house this summer and just when the weather turned we realized that the 8 year old Goodman furnace in our basement had rusted heat exchange pipes and was leaking carbon monoxide. (So much for the $400 I paid to an home inspector before we moved in...) Fortunately, the furnace had a warranty still active. Not so fortunately, Goodman was incompetent in getting us the replacement part. It took them a month to send it, and then it wasn't even the right part. Don went to bat for us and convinced Goodman to foot the bill for an entirely new furnace! He and another worker made time in their busy schedule during thanksgiving week to come out and get the unit installed. This is above and beyond service and I couldn't be happier.
There’s a common misconception that you can save money by shutting the vents (supply registers) in rooms that aren’t being utilized. Resist the urge to close too many, as doing so can actually increase the pressure in your furnace, making it work harder to heat your home. This can lead to failed blower motors, mold or mildew in your ductwork, damage to the compressor, a cracked heat exchanger, and other problems. What Does a Furnace Tune-Up Include?

Whether you are looking for gas furnace service or repair, quality installation of a furnace, heat pump or air conditioner, mini split ductless heat pumps, endless hot water from tankless water heaters, better air quality in your home or just a filter change or duct cleaning, Greenwood Heating is your best choice of Seattle heating contractors and cooling specialists.

Ultimately, the cost to repair your furnace depends on a wide range of variables. From the brand of the units to the damaged or broken parts, you need a reliable and trusted professional who can evaluate the issue and recommend next steps. If you're unsure whether to repair or replace your furnace, or even where to begin, connect with a local furnace repair professional who can make sure that your home heats well both now and in the future.


As a Carrier Factory Authorized Dealer, M and M, Heating & Cooling, Plumbing & Electrical is qualified to properly size and install the most technologically advanced and well-regarded heating, cooling, and air quality products on the market today. Our team is NATE-certified, factory trained, EPA certified, and regularly updated, ensuring the right solution to any challenge.
While repair is often the preferred choice, problems like a consistent repeating complication or extra-costly furnace repair parts might start leading you in a different direction. Remember that repair is only the preferred option when the cost of seeking it makes sense! If you’re shelling out for repair every single year, then it might be time to talk to your heating contractor about furnace replacement.
I have a Bosch condenser dryer that heats up and after 3-5 mins cuts out (no lights/power). After is cools a while, the machine can be restarted and runs a while longer until it shuts down again. This process repeats several times, with each progressive drying cycle being a little longer than the previous until the clothes are eventually dry.I've tested the the thermal-protector for continuity and the NTC-sensor on the heating element appears to be fine (tested for resistance). Could it be a faulty sensor/component on the control board that's getting too hot and cutting out the power? And if so, can it be easily identified/replaced, or would I need to replace the whole control board?Any help would be greatly appreciated!
If your furnace’s motor runs but the blower doesn’t move air, the belt that connects the two probably has broken. Replacing it is an easy fix. First, turn off all power to the unit and turn off the gas at the gas valve that serves the furnace. Remove the door on the front of the furnace cabinet to give you access to the blower (it might be on a slide-out drawer.) Check the number stamped on the belt and get an exact replacement from a home center or heating supply outlet.

We have done furnace services numerous times for last 10+ years. All that this technician did was to vacuum inside the furnace, asked me to turn on and turn off furnace, and said it is working fine. He didn't clean the burners, didn't check heating effectiveness, didn't check / change the filter ... Total rip off. I am calling amazon customer service.
Though Houston heating isn’t a well-known issue, there are occasions when repairing a broken furnace is absolutely necessary. When you need heating system repair, installation, or maintenance, Abacus Plumbing will be able to help you with all your heating repair needs. We’ve been in the heating business for years and because of our HVAC expertise, our professionalism, and excellent customer service, our customers call us the best heating repair company in Houston!
While repair is often the preferred choice, problems like a consistent repeating complication or extra-costly furnace repair parts might start leading you in a different direction. Remember that repair is only the preferred option when the cost of seeking it makes sense! If you’re shelling out for repair every single year, then it might be time to talk to your heating contractor about furnace replacement.
Gas furnaces and heaters have control shutoffs to prevent gas leaks, but they are not fail-safe. If you smell gas in your house, do not turn any lights on or off, and do not try to shut off the gas leading to the furnace. Get out of the house, leaving the door open, and immediately call the gas company or the fire department to report a leak. Do not re-enter your home.

I'd had them come out before and called because my thermostat wasn't getting power. They said they don't service townhomes. I said that must be a new policy because they've been out before and she said they've had it for awhile. I tried to ask why they don't service townhomes and she said they don't service attached homes or commercial properties. I said that my home isn't commercial and it doesn't really answer my question, but I guess I'll go elsewhere. I couldn't find this policy on their website and I can't really understand why a townhome furnace would be different than an unattached home. When they came out before I seem to remember they did a good job, so it's too bad they have odd policies now.
Of the various contractors and HVAC service companies, why should you choose AQS for air conditioning and furnace repair? Our company is a family-owned and operated business that has been in business since 1996. It goes without saying that we are extremely experienced in the installation and repair of heating and cooling units. We are proud of our A+ rating from the BBB, and we have received numerous Super Service Awards from Angie's List, both in recognition of the quality services we provide.
Over the past twenty years, we have used a number of different heating and cooling companies, none impressed us to use them more than once or twice. The service provided by A-TEMP was so outstanding; they will be our heating and cooling service provider for LIFE! Exceptional all around! It is nice to know why our home has three temperature zones and what we could do to improve it; plus the costs. Also, to understand the importance of regular maintenance-especially as it relates to carbon monoxide emissions. We appreciate the forewarning that our new system would be noisier due to the increased volume in our return system. We feel so blessed to know we do not have carbon monoxide emissions now and the furnace is the right size for our home. We feel like we won a million dollars with our new system!
CM Heating performed a Gas Furnace Diagnostic. Customer wanted his echo bee thermastat installed that he had bought himself. Furnace was working fine just wanted his thermastat installed. He thought that the $99 service fee was going to cover that but explained to him what the service fee was for, and explained that there is a additional install fee for the stat. Customer didn’t want to pay the additional fee so I called the office had them listen to the call to make sure we explained to the customer correctly and to see how they would like me to proceed. So I quoted the customer the fee to install the thermostat but he didn’t want us to install it so I left.
Though Houston heating isn’t a well-known issue, there are occasions when repairing a broken furnace is absolutely necessary. When you need heating system repair, installation, or maintenance, Abacus Plumbing will be able to help you with all your heating repair needs. We’ve been in the heating business for years and because of our HVAC expertise, our professionalism, and excellent customer service, our customers call us the best heating repair company in Houston!
I have a Bosch condenser dryer that heats up and after 3-5 mins cuts out (no lights/power). After is cools a while, the machine can be restarted and runs a while longer until it shuts down again. This process repeats several times, with each progressive drying cycle being a little longer than the previous until the clothes are eventually dry.I've tested the the thermal-protector for continuity and the NTC-sensor on the heating element appears to be fine (tested for resistance). Could it be a faulty sensor/component on the control board that's getting too hot and cutting out the power? And if so, can it be easily identified/replaced, or would I need to replace the whole control board?Any help would be greatly appreciated!
Next check and clean the furnace’s flame sensor. The video below shows you how—note that this guy fixes it in about 5 minutes. We would probably use a little bit of emory paper, but he cleans the sensor with a 5-dollar bill. Another video further down the page under the discussion of “If your furnace keeps shutting off after about 5 minutes” shows the same project with a different brand of furnace.
×