A whole–house air conditioning system in Federal Way, WA is by no means a luxury, but a necessity. At Bob’s Heating & Air Conditioning, our Federal Way air conditioning system specialists work with customers to ensure that their homes are comfortable all summer long. There is simply no other way to ensure that you and your family are cool during the summer than by having your cooling system service completed by a professional Federal Way air conditioning technician.

CM Heating performed an electric furnace Diagnostic - Upon investigation, I found that the sequencer has failed which is why all heat elements are not being activated (3 out of 5 work). This is the second replacement sequencer needed in less than 5 years of operation, the unit is an old model of air handler and only source of heat. Replacement of sequencer is needed, however, based on age and efficiency recommend upgrade of system.

The cost to replace your gas furnace will vary based on the type and size of furnace you select, labor and installation costs, and any repairs your HVAC system may need. Nationally, average HVAC prices for a heating specialist range between $1,800 and $2,500. It’s important to select the right size gas furnace for your heating needs. A furnace that’s too small won’t heat your house properly, while a furnace that’s too large will run inefficiently, cycling on and off and likely breaking down sooner. HVAC specialists calculate your exact heat needs by measuring your home and incorporating variables such as the regional climate and your home’s level of insulation. Retail pricing for gas furnaces can range from $650 up to $3,000 and more. The higher the AFUE (annual fuel utilization efficiency) rating of the furnace, the more efficient it is at turning fuel into heat and the lower your carbon footprint and utility bill will be. HVAC installation costs are often based on an hourly rate and can range from under $50 to over $100 per hour, depending on the company and the furnace being installed. Higher-end furnaces cost more to install because they require added labor and expertise. For a typical installation, it might take two HVAC installation pros one day or less to remove your old furnace and replace it with a new one.
Of the various contractors and HVAC service companies, why should you choose AQS for air conditioning and furnace repair? Our company is a family-owned and operated business that has been in business since 1996. It goes without saying that we are extremely experienced in the installation and repair of heating and cooling units. We are proud of our A+ rating from the BBB, and we have received numerous Super Service Awards from Angie's List, both in recognition of the quality services we provide.
When choosing a heating and cooling company, it's important that you find one that employs licensed, highly trained, background-checked, and drug-tested technicians. Considering this person will be in your home, it would be nice if the technician is also well-groomed, honest, polite, informative, and will give you options on how to improve your comfort.

As your water heater operates it will incur some general wear and tear; there is no way to prevent this. With the help of a Seattle, WA water heater maintenance specialist, though, you can keep this wear and tear from developing into major headaches down the road. We’ll make sure that your water heater is in the great operating condition you deserve.
So the furnace went out (again). We’re probably not the people you want to be dialing, but in these circumstances, Service Experts Heating & Air Conditioning in North America should be your very first call. You don’t even have to worry how late (or early) it is – our NATE-certified technicians available at all hours, every day of the year. We’ll be there in a jiffy and get the job done fast – so you can get back to your routine and not have to even think about needing another furnace repair anytime soon.
Ruud, Trane, and American Standard are among the more reliable natural gas furnace brands, whereas Goodman, Lennox, and Amana are among the less reliable brands. York, however, stands out as the least reliable brand and cannot be recommended by Consumer Reports at this time. That’s what we found based on the feedback of 21,618 subscribers, who reported on their experiences with gas furnaces installed between 2011 and 2016.

When choosing a heating and cooling company, it's important that you find one that employs licensed, highly trained, background-checked, and drug-tested technicians. Considering this person will be in your home, it would be nice if the technician is also well-groomed, honest, polite, informative, and will give you options on how to improve your comfort.


If I could give them 10 stars I would. Don is extremely knowledgeable but more importantly honest. PSE had done a free diagnosis and told me I would need a new induction motor for around $850 or possibly a new furnace. PSE doesn't do the repairs so I found Affordable furnace on yelp. Don showed me where the noise was coming from and that we didn't need the other repair. He performed some routine maintenance and enlightened me on much better furnace filters. He said we will probably need a new furnace in a couple years but given the fact we've lived here 18 years and it was here before we got here I think we're doing pretty good. When it is time for a new furnace there's only one company we will be calling. Thanks Affordable Furnace!
Furnace replacement in Denver is necessary if your furnace is broken beyond repair or if it is more than 15 years old. Old furnaces are very inefficient (they use more power and gas than newer ones) and they can even be very hazardous to your health and home. Furnaces are controlled fires, and when the control systems for said fires are out of date or malfunctioning, the safety and wellbeing of your home are in jeopardy. So if you have an old or malfunctioning heater, then give our furnace replacement company a call today.
You can usually slip the belt on the motor’s (smaller) pulley first and then start it on the blower pulley. Rotate the blower pulley by hand, holding the belt in place but keeping your fingers from getting caught between the belt and the pulley. The belt should slip right into place. If it seems to be too tight or difficult to set in place, it may be necessary to adjust the motor mount to provide more slack.
When your furnace isn’t regularly serviced it can operate less efficiently. This increases your energy bills and also prevents your furnace from keeping your home as warm as you like. Keep your furnace properly maintained with regular service. The national average furnace service cost is between $60 and $80. Companies may offer tuneup specials that cover all the necessary testing, tightening, measuring and cleaning to keep your equipment running at top efficiency. If you have a newer system, furnace service costs may be covered by your warranty. Outside of warranty, a basic tuneup might start at $58 and a more advanced maintenance cleaning could be over $120. Here are some signs your furnace may need service:
Heat pumps act like an air conditioner in the summer, removing the heat from the air and then recirculating the cooled air throughout your home. In the winter, though, they can transfer ambient heat from outside into your house, efficiently warming your home with minimal energy consumption. If you do decide on a heat pump in Seattle, WA, make sure that you schedule your installation, maintenance and repair services with a skilled, qualified technician.
Heat pumps that wring heat from outdoor air (and reverse the process in summer to act as an air conditioner) are inexpensive to install as an alternative to a cooling-only air-conditioning system. That makes them the preferred way to heat in the South and Southwest, where winters are typically short and mild. Heat pumps that wring heat from the ground are much more expensive to install, but they are suitable for cold climates because they can maintain their operating efficiency. Other inexpensive electric-heat options include strip heaters, which are installed in the ductwork of central air conditioning, and permanently installed baseboard units in each room. But before you consider any type of electric central heating in colder regions, keep in mind that electricity rates are much higher than those for natural gas and are likely to remain that way for the foreseeable future. You can get rate information for various fuels from local utilities and suppliers.
This makes heat pumps a highly energy efficient solution. At Bob’s Heating & Air Conditioning, our Federal Way heat pump specialists often recommend heat pumps because they allow our customers to use a single system year–round. As a highly energy efficient device, your heat pump may also save you money in the long term. Let us take care of your heat pump needs in Federal Way, WA, whether that’s installation or repair.

We offer a wide range of air conditioning services in Federal Way, WA, from the installation of new systems from scratch to the replacement of old models that have seen better days. We can also make sure that your air conditioner is routinely cleaned and inspected with our routine maintenance. As always, our air conditioning technicians are available to repair your AC at a moment’s notice. Call us today for professional air conditioning service.


As a Bryant Factory Authorized Dealer, we meet rigid criteria for technical training, customer approval ratings, and insurance coverage. Serving the Chicagolands North Shore since 1940, we’ve honed our services to accommodate local issues and ensure maximum reward. Improving the health of our customer’s home and lifestyle, Effective Air offers cost-effective and expert service throughout Glenview, Kenilworth, Wilmette, Winnetka, Evanston & Northbrook, IL.
Ultimately, the cost to repair your furnace depends on a wide range of variables. From the brand of the units to the damaged or broken parts, you need a reliable and trusted professional who can evaluate the issue and recommend next steps. If you're unsure whether to repair or replace your furnace, or even where to begin, connect with a local furnace repair professional who can make sure that your home heats well both now and in the future.
When your gas furnace isn’t blowing hot air, the issue could be due to a faulty pilot light or broken ignitor. Remove the furnace cover panel and visually inspect whether you can see a flame from the pilot light. A natural gas furnace will be blue and yellow in color, and a propane furnace should have a bluish green flame with a yellow tip. If you can see a flame and it appears normal, the issue could be related to the furnace blower motor or other complex furnace parts. If the flame appears low or non-existent, it’s best to contact an experienced furnace repair company. Remember to never touch any open wires; contact a professional.
You can make your home more energy-efficient in several ways. Turn down the thermostat in winter; just two degrees cooler will save you money and reduce emissions by about 6 percent. You might not even feel the difference, especially at night or when you're out of the house—a programmable thermostat can help here. Draw the curtains at night to block the chill from a cold window. Keep the windows covered on sunny days during the summer, and uncover them on sunny days during the winter to benefit from some free solar heating. Reduce heat loss from ducts by sealing leaks and, where feasible, insulating ducts.
Cut down on energy costs and prevent damage to your furnace by addressing a gas furnace that's overactive or short cycling. Besides the need for consistently comfortable temperatures, this issue could cause long-term safety issues to your home, making it very important to address. From a faulty thermostat to a dirty filter, there are several possible causes to investigate.
×