Heat pumps that wring heat from outdoor air (and reverse the process in summer to act as an air conditioner) are inexpensive to install as an alternative to a cooling-only air-conditioning system. That makes them the preferred way to heat in the South and Southwest, where winters are typically short and mild. Heat pumps that wring heat from the ground are much more expensive to install, but they are suitable for cold climates because they can maintain their operating efficiency. Other inexpensive electric-heat options include strip heaters, which are installed in the ductwork of central air conditioning, and permanently installed baseboard units in each room. But before you consider any type of electric central heating in colder regions, keep in mind that electricity rates are much higher than those for natural gas and are likely to remain that way for the foreseeable future. You can get rate information for various fuels from local utilities and suppliers.

Our goal is to make you more comfortable in your home. When your furnace, central air conditioner, heat pump or boiler stops working and you need service, call the professionals at BGE HOME. Heating and cooling system breakdowns occur at the most inconvenient times, so rely on our certified, skilled technicians to make the repair quickly and correctly the first time.
Natural gas furnaces operate similarly to the above, using a pilot light to ignite the burners and heat up the air. Also similar to propane gas, your average repair costs for a natural gas furnace will range anywhere from $125 for small repairs to $1,200 if you have to replace the entire heat exchanger. The difference between both options is not necessarily the actual furnace, but the type of gas used to burn through it and heat your home. As a result, the repair costs tend to be close to identical.

I have a Bosch condenser dryer that heats up and after 3-5 mins cuts out (no lights/power). After is cools a while, the machine can be restarted and runs a while longer until it shuts down again. This process repeats several times, with each progressive drying cycle being a little longer than the previous until the clothes are eventually dry.I've tested the the thermal-protector for continuity and the NTC-sensor on the heating element appears to be fine (tested for resistance). Could it be a faulty sensor/component on the control board that's getting too hot and cutting out the power? And if so, can it be easily identified/replaced, or would I need to replace the whole control board?Any help would be greatly appreciated!
If your heating system in Everett, WA is not working it is likely your furnace needs repair or service. At times the fix is simple, other times it is not. Our heating and furnace service technicians have years of experience working on furnaces like yours in Everett, WA. C.M. Heating has service vehicles on call that are fully equipped with the tools and parts necessary to get your furnace back up and operating. 

Don has earned a lifetime customer! My wife and I moved into our fixer-upper house this summer and just when the weather turned we realized that the 8 year old Goodman furnace in our basement had rusted heat exchange pipes and was leaking carbon monoxide. (So much for the $400 I paid to an home inspector before we moved in...) Fortunately, the furnace had a warranty still active. Not so fortunately, Goodman was incompetent in getting us the replacement part. It took them a month to send it, and then it wasn't even the right part. Don went to bat for us and convinced Goodman to foot the bill for an entirely new furnace! He and another worker made time in their busy schedule during thanksgiving week to come out and get the unit installed. This is above and beyond service and I couldn't be happier.

High-efficiency condensing furnaces (90% AFUE and above) are a bit more complex than conventional furnaces. The main differences between a conventional and condensing furnace is the heat exchanger technology used to extract heat from the combustion process and the method used to exhaust the combustion gases. In these ways, the furnaces are very different. The condensing furnace does not have a significantly more efficient combustion process than does a conventional furnace; both use gas burners with electronic ignition. The difference lies in that the condensing furnace has a more efficient heat extraction process after combustion.
×