If your thermostat has a small lever that moves along a calibrated scale that indicates “longer” (not the heat temperature lever), you can try adjusting this—the heat anticipator. Just set it one calibration mark closer to the “longer” setting if the furnace goes off and on too frequently or one mark away if the furnace allows room temperature to rise too high or drop too low before going on or off. It may take several hours for the thermostat to stabilize at this setting, so wait a while and then adjust it again if necessary.

In Denver, Brothers Plumbing, Heating and Electric have been providing plumbing, heating, and electric services for over 30 years. The family owned and operated company was founded in 1980. The specially trained technicians continuously provide prompt, professional, quality services. We provide top of the line customer service and a guarantee on the work done. Your search for reliable furnace repair ends here.
The motor belt should be firm, giving no more than ½ inch when pressed. It should also be free of cracks and damage. To remove the belt, you will need a wrench and a replacement belt. Loosen, do not remove, the motor bolts. You only need them loose enough to move the motor and slacken the belt. Remove the belt and inspect it, replacing it with a new one if necessary. Belt: $4.00 to $6.00.

The motor belt should be firm, giving no more than ½ inch when pressed. It should also be free of cracks and damage. To remove the belt, you will need a wrench and a replacement belt. Loosen, do not remove, the motor bolts. You only need them loose enough to move the motor and slacken the belt. Remove the belt and inspect it, replacing it with a new one if necessary. Belt: $4.00 to $6.00.
When it comes to heater repair in Denver, a properly serviced system means significant savings for the homeowner. When a Denver heating technician inspects your system before the winter sets in, the first thing they will check is the condition of the air filters. These filters are important, because they are responsible for removing contaminants, allergens, and dust particles from the air every time the system is turned on. When the filters are clogged, expect more particles to easily pass through right into the air you breathe inside the home. The Denver heating experts will inspect and replace any filters that are no longer effective.

Dirty furnace filters are one of the most common causes of a furnace failure. A dirty furnace filter can limit the airflow through your furnace and cause it to overheat. If you suspect a dirty air filter, change the filter, press the reset button (if your furnace has one) and see whether your furnace begins to emit heated air. Change your furnace filters regularly — pros recommend changing them once a month — to ensure that your furnace continues to work properly. Unaddressed, dirty furnace filters can cause extensive, and expensive, damage to your home’s heating system.

Lennox is another leading manufacturer and marketer of gas central furnaces. Lennox central furnaces are available in single and multistage configurations, with some models capable of an AFUE rating of more than 90 percent. Lennox markets units that meet Energy Star requirements and makes others that it claims offer quiet operation. The average price of a Lennox central gas furnace is about $2,500 and Lennoxes are sold through their dealer network.
As you decide, insist that the contractor select models in a range of efficiencies and calculate the annual estimated operating cost of each model you're considering, rather than simply estimating it. The contractor can complete those calculations by plugging information on each unit's AFUE and electrical consumption, local utility rates, and characteristics of your home into one of several computer programs designed to easily calculate estimates. Make sure that the quotes also include the cost of any changes to venting required by any appliances in the home.

As your air conditioner operates, it is going to suffer some general wear and tear. There is really no way in which to avoid this. However, wear and tear does not have to result in serious problems with your air conditioning system. Just make sure that you schedule professional air conditioning maintenance in Seattle, WA in order to keep your system in great working condition.


When it comes to air conditioning installation in Federal Way, WA, you need to make sure that you hire a professional to ensure that the job is done right the first time. Let us take care of every detail. At Bob’s Heating & Air Conditioning, our Federal Way air conditioning installation technicians are highly trained and experienced to handle a number of different system types and brands.
To keep your furnace in good working order it’s important to have it regularly cleaned. The national average furnace cleaning cost ranges from $60 to $80, though prices can vary greatly based on where you live in the country and what your furnace maintenance includes. An HVAC company may have different rates for different levels of furnace maintenance. For example,one company may offer general furnace maintenance for $79 and advanced maintenance for $138. Another company may offer a 38-point maintenance check for $89 and a 64-point maintenance check for $178. According to Energy.gov, a standard furnace cleaning and maintenance visit can include:
When you change the temperature on your thermostat, or the temperature in your home drops, a signal lets the furnace's igniter know that it's time to turn on. Igniters exist in both hot water boilers and forced air furnaces, replacing pilot lights as the switch your unit needs to kick on. Naturally, this is a core part in making sure it works reliably. When it stops working, your unit will not longer know when to actually heat your home. Fortunately, furnace igniter repair doesn't tend to be a major budget problem, and costs less than $300 on average.

Having a company take care of all your heating and cooling needs shouldn’t indicate that you’re stuck with any ordinary shop who cuts corners. Heating and cooling has been our excitement since 1967, and it’s apparent in the work we offer to our customers. We’re committed to offering you the very best when it comes to all things HVAC, whether it’s service, maintenance or heating and cooling systems.
We’ve earned a reputation across Portland and The Dalles for dedicated customer service.  Consistently maintaining an A+ rating from the Better Business Bureau, Sky Heating & Air Conditioning meets higher standards of excellence through the little, important details that add up to a job well done.  It starts with a friendly voice on the phone, and the immediate focus of our extensive resources on your requirements.  From there, you can count on timely arrival, organized project management, careful cleanup, competitive pricing, and exemplary performance in every aspect of service.  When you contact Sky Heating & Air Conditioning for HVAC service in The Dalles and Portland, OR, your project is always handled by a highly-trained professional, who will achieve your goals for efficiency, reliability, and sustainable home comfort.

If you’re looking for a professional heating company in Denver with the proper experience to handle your project, our crew has many years of training and experience on most major heating systems available in the Denver area. Our heating company in Denver understands that in some situations, the scope of the damage may put the units beyond repair. In this instance, we can offer you help finding the right energy efficient model that will provide you warmth and savings in your wallet. Heating in Denver can be expensive during the coldest time of year, so choosing the right heating system can give the same amount of heat while at the same time providing big savings when our Denver heater repair technicians help you pick the right system for your home.

Ashworth Heating & Cooling provides an affordable and reliable source of heating, cooling, air quality, and refrigeration services.  Specializing in installation, equipment updates, and maintenance repair, for both residential and commercial application, we ensure cost-effective solutions to every type of challenge.  Our goal is to simplify your life, minimize disruption, and optimize the performance of your essential systems.  When you contact Ashworth Heating & Cooling, we make it convenient to get the information, recommendations, and assistance you need, and deliver rewarding results in Hurricane, Huntington, Charleston, South Charleston, St. Albans, Dunbar & Milton, WV and all of the Tri-Country Area.

Having a company take care of all your heating and cooling needs shouldn’t indicate that you’re stuck with any ordinary shop who cuts corners. Heating and cooling has been our excitement since 1967, and it’s apparent in the work we offer to our customers. We’re committed to offering you the very best when it comes to all things HVAC, whether it’s service, maintenance or heating and cooling systems.


Your heating and air conditioning system naturally loses energy efficiency over time. This loss of efficiency is due to many factors, including dust and dirt, natural wear and tear, and buildup in drains or on burners. Keeping your heating system maintained with regular professional tune-ups can help to reduce these factors. During your tune-up, your maintenance technician will clean and check over your heating equipment, identifying areas of wear and tear. They can identify failing parts in need of replacement before they become a serious problem. A tune-up alone may instantly improve energy efficiency by up to 30%. You’ll also enjoy cleaner air and a cleaner residence because your HVAC system will be distributing clean air through a clean air filter. Perhaps one of the greatest benefits you’ll enjoy following a fall furnace or AC tune-up is decreased utility bills. A neglected HVAC system must work much harder to heat and cool your home, while a furnace or air conditioner that has been finely tuned can take less energy to maintain indoor comfort. Because your heating system will function more efficiently, it will deliver superior heating at lower cost than you otherwise may have had through the winter season.
I'm so impressed and happy that I called Affordable Furnace Repair!  Not only did they come out same day, but they were early and quick.  They even showed me how I can try to fix it myself next time.  And they were so nice and friendly!  Sometimes it's weird to invite people into your home to work on something, but this wasn't weird or awkward to me.  I feel like I'm gushing here, but I'm so happy our heat is working again so quickly!
When you trust your winter comfort to Edwards Heating & Air, we answer with state-of-the-art technology, NATE-certified technicians, and prompt action.  As a Carrier Factory Authorized Dealer, we specialize in the most proven and sophisticated solutions to home and commercial temperature control.  Through ongoing factory training and strict installation and service procedures, the team from Edwards Heating & Air delivers superior workmanship and superior results.  We ensure your demands for efficiency, reliability, and consistent heating are met, and your expectations for courteous and skilled service are exceeded.  Whether you are in the process of building your dream home, in need of effective heating for your existing home or business, or upgrading your furnace or heat pump, our installation specialists provide informed recommendations, attention to detail, and quick turnaround on your project.  Serving Acworth and the surrounding areas of Acworth, Alpharetta, Cummings, Cartersville, Kennesaw & Woodstock, GA since 2001, you can count on Edwards Heating & Air for everything from installation and maintenance to emergency repairs.
Yes. You should expect to pay a diagnostic fee to cover the cost of the technician's visit, the diagnosis of your air conditioner's problem, and a quote for the repair options. You will be advised of the issue along with recommended options to correct it, which may include a system replacement if your unit is old or significantly damaged. If you decide to replace the system, the diagnostic fee will be credited toward your replacement purchase.

A number of other variables can influence your decision on whether to repair or replace your furnace, as well. In addition to cost and brand, consider the expected lifetime of your furnace. If it is more than 15 years old, it might make more sense to invest in a new unit even if it costs more than simply repairing the current problem. Long-term costs also play into the equation. For example, your new furnace may be more energy efficient than the current unit. Even though you will pay more for the actual installation, you might be able to make back your investment through lower energy bills. To make your decision, consult with a reliable professional on what to do. In inspecting your furnace, they will be able to make an informed recommendation that looks not just to the next year, but years into the future. That way, you can make the best possible decision for your home and budget long-term.


I have a Bosch condenser dryer that heats up and after 3-5 mins cuts out (no lights/power). After is cools a while, the machine can be restarted and runs a while longer until it shuts down again. This process repeats several times, with each progressive drying cycle being a little longer than the previous until the clothes are eventually dry.I've tested the the thermal-protector for continuity and the NTC-sensor on the heating element appears to be fine (tested for resistance). Could it be a faulty sensor/component on the control board that's getting too hot and cutting out the power? And if so, can it be easily identified/replaced, or would I need to replace the whole control board?Any help would be greatly appreciated!

At Genz-Ryan, we are here for you 24 hours a day, 7 days a week so you can count on us for all your heating repair work in the Minneapolis area. Our furnace repair technicians are well-trained and experienced. They’re ready to take care of any heating issue that you may have. We are a Lennox Premier Furnace Dealer and provide expert furnace repair service for most of the Minneapolis/St. Paul area. For over 60 years we have been getting the job done right the first time.
×