The cost to replace your gas furnace will vary based on the type and size of furnace you select, labor and installation costs, and any repairs your HVAC system may need. Nationally, average HVAC prices for a heating specialist range between $1,800 and $2,500. It’s important to select the right size gas furnace for your heating needs. A furnace that’s too small won’t heat your house properly, while a furnace that’s too large will run inefficiently, cycling on and off and likely breaking down sooner. HVAC specialists calculate your exact heat needs by measuring your home and incorporating variables such as the regional climate and your home’s level of insulation. Retail pricing for gas furnaces can range from $650 up to $3,000 and more. The higher the AFUE (annual fuel utilization efficiency) rating of the furnace, the more efficient it is at turning fuel into heat and the lower your carbon footprint and utility bill will be. HVAC installation costs are often based on an hourly rate and can range from under $50 to over $100 per hour, depending on the company and the furnace being installed. Higher-end furnaces cost more to install because they require added labor and expertise. For a typical installation, it might take two HVAC installation pros one day or less to remove your old furnace and replace it with a new one.

• If your furnace is inside the house, it may be located in an area that is magnifying the sound it makes – such as under a staircase. Often moving the furnace to another part of the house can reduce that noise. You may find that it’s in an area that was previously occupied by another older type of furnace, and you never heard those sounds from that one. Please keep in mind that modern furnaces are built differently – with multiple speeds and stages – which may create different sounds and require more airflow than your old ductwork has available. If the furnace doesn’t get enough air, it gets cranky.


This feature uses a number of thermostats, a sophisticated central controller, and a series of dampers that control airflow to deliver different amounts of heating or cooling to different parts of the home. The larger the home, as a rule, the more useful zoning is. That's especially true if sections of the home have different heating or cooling requirements, because of wide variations in the number or type of windows, for example. But contractors we interviewed said that furnaces connected to zoned ductwork generally require more repair.
CM Heating performed an electric furnace Diagnostic - Upon investigation, I found that the sequencer has failed which is why all heat elements are not being activated (3 out of 5 work). This is the second replacement sequencer needed in less than 5 years of operation, the unit is an old model of air handler and only source of heat. Replacement of sequencer is needed, however, based on age and efficiency recommend upgrade of system.
Furthermore, routine water heater maintenance also ensures that your system works as it should. When dust and other sediment build up within the tank or on other components, they can present serious problems for energy efficiency and hot water capacity. Let our Federal Way water heater maintenance specialists keep your water heater in good working order.
The cost of a new furnace might make you balk at first thought, but with modern manufacturers offering an extremely diverse range of options with varying AFUE ratings, optional accessories, and more, there is a furnace to meet any budget! It’s just important that you work with the right service team and experts that will work with you rather than try to “sell” you.

2Be sure the furnace’s circuit breaker is on or that its fuse has not blown. Check both the main electrical panel and any secondary subpanels that supply power to the unit. If the circuit has blown or tripped, reset the circuit breaker by flipping it all the way off and then on again. Or replace the fuse. If the circuit blows again, there is probably a short in the electrical system providing power to the furnace. For this, you may need to call an electrical contractor.


This is probably the most common question we hear. To give an accurate price, we need to get a safety certified technician out to your home in a fully stocked truck to take a look at your particular situation. Our technician will give you a precise price with your options BEFORE any work begins. Each of our technicians are well trained, experienced, drug tested and background checked so that you can rest easy knowing your services will be performed in a timely and professional manner. If you need help paying for your services, we even offer financing with approved credit through Wells Fargo. Click here to learn more about our financing services.
Whether you are looking for gas furnace service or repair, quality installation of a furnace, heat pump or air conditioner, mini split ductless heat pumps, endless hot water from tankless water heaters, better air quality in your home or just a filter change or duct cleaning, Greenwood Heating is your best choice of Seattle heating contractors and cooling specialists.
If your heating system in Everett, WA is not working it is likely your furnace needs repair or service. At times the fix is simple, other times it is not. Our heating and furnace service technicians have years of experience working on furnaces like yours in Everett, WA. C.M. Heating has service vehicles on call that are fully equipped with the tools and parts necessary to get your furnace back up and operating.
But even if your system is not yet at its breaking point, there are other reasons to consider professional air conditioning replacement service in Federal Way, WA. For example, if you find that your AC is highly inefficient because of its age or damage, then it may make more financial sense to invest in a new system so that you can take advantage of today’s energy efficient technology.
Given the broad price ranges above, it's easy to recognize that the cost of your furnace repair varies drastically based on which parts need attention. As a result, it makes sense to gain a better understanding of the parts that heat your home, and how much they cost to repair. Repairing or replacing your furnace’s blower motor can cost you anywhere between $150 and $450, depending on the extent of the damage. Heat exchanger repair costs can vary greatly, from as little as $100 for a simple fix to as much as $1,200 for a full replacement. Repairing a furnace igniter will only cost you $300 at most, while flame sensor repairs generally fall between $80 to $250. The average cost to repair your Thermostat will range from $108 to $282.
You cannot afford to gamble with your comfort. If your air conditioner is not expertly installed, routinely maintained and professionally repaired, you are really putting your comfort at risk. Our Seattle, WA air conditioning experts have the experience and training they need to ensure that your air conditioner is ready for action when temperatures rise.
We are so happy we selected Clarence with CAL Property Care to repair our furnace. He was very easy to schedule an appointment with and actually came out on a Saturday to figure out what the issue was. Clarence had to order a part to complete the repair, but he promptly updated us with the progress every step of the way. Clarence really went above and beyond and I can't say enough for his friendly attitude and quality of work! Thanks again Clarence!
We are aware that furnace repair in Denver can be pricey depending on what is malfunctioning. We are always ready to work with you within affordable means. You should not be overwhelmed or worried. We will help you maintain your system longer by treating parts, replacing filters, and cleaning the system. Prior to any furnace repair in Denver, diagnosis is a priority. We always aspire to be the best when satisfying all our customers from the moment you call to the time we leave your home. We analyze your heating system thoroughly and offer you furnace repair that is economical. Contact us for immediate assistance in Denver. To learn what it takes to become one of our team of professional furnace repair technicians, just click HERE.
Our company’s strength lies in our years of experience performing air conditioning and heating repair in Voorhees, Sewell, Haddonfield, and other towns in and around South Jersey. We also take pride in the high standard we set for the quality of our AC repair and work, and our unfaltering dedication to our customers located in Haddonfield, Sewell, and other parts of Jersey. For three generations we have kept these ideals at the forefront of our operations, allowing us to continue to be one of Southern New Jersey’s leading HVAC Contractors and air conditioner companies.
In addition to our gas and electric furnace installation, our Federal Way furnace technicians also make certain that your existing furnace works well for years to come with our furnace repair and maintenance services. Whether your furnace has broken down and no longer functions effectively, or you want to stave off problems by having it routinely maintained, we can help.
But even if your system is not yet at its breaking point, there are other reasons to consider professional air conditioning replacement service in Federal Way, WA. For example, if you find that your AC is highly inefficient because of its age or damage, then it may make more financial sense to invest in a new system so that you can take advantage of today’s energy efficient technology.

Tyson from Brothers was courteous, efficient and familiar with the system, because he had worked with it before. He arrived early within the time window and was professional, fast and made it possible for me to happily spend my day doing other things rather than devoting all day to the sprinkler turn off procedure and worrying if the job had been done properly.


Next check and clean the furnace’s flame sensor. The video below shows you how—note that this guy fixes it in about 5 minutes. We would probably use a little bit of emory paper, but he cleans the sensor with a 5-dollar bill. Another video further down the page under the discussion of “If your furnace keeps shutting off after about 5 minutes” shows the same project with a different brand of furnace.
At Genz-Ryan, we are here for you 24 hours a day, 7 days a week so you can count on us for all your heating repair work in the Minneapolis area. Our furnace repair technicians are well-trained and experienced. They’re ready to take care of any heating issue that you may have. We are a Lennox Premier Furnace Dealer and provide expert furnace repair service for most of the Minneapolis/St. Paul area. For over 60 years we have been getting the job done right the first time.
×