There’s a common misconception that you can save money by shutting the vents (supply registers) in rooms that aren’t being utilized. Resist the urge to close too many, as doing so can actually increase the pressure in your furnace, making it work harder to heat your home. This can lead to failed blower motors, mold or mildew in your ductwork, damage to the compressor, a cracked heat exchanger, and other problems. What Does a Furnace Tune-Up Include?
If you need a furnace repaired or an air conditioner serviced, we'll send a local technician out to diagnose the specific problem and recommend solutions for you and your family. There will be a diagnostic fee for the visit, and any specific repairs will be an additional charge. If replacing your system is the best solution, the fee for the diagnosis will be credited toward the purchase and install of a new system.
If you’re looking for a professional heating company in Denver with the proper experience to handle your project, our crew has many years of training and experience on most major heating systems available in the Denver area. Our heating company in Denver understands that in some situations, the scope of the damage may put the units beyond repair. In this instance, we can offer you help finding the right energy efficient model that will provide you warmth and savings in your wallet. Heating in Denver can be expensive during the coldest time of year, so choosing the right heating system can give the same amount of heat while at the same time providing big savings when our Denver heater repair technicians help you pick the right system for your home.
Heat pumps act like an air conditioner in the summer, removing the heat from the air and then recirculating the cooled air throughout your home. In the winter, though, they can transfer ambient heat from outside into your house, efficiently warming your home with minimal energy consumption. If you do decide on a heat pump in Seattle, WA, make sure that you schedule your installation, maintenance and repair services with a skilled, qualified technician.
Keeping too many heat registers closed can cause heat to build up in your furnace, forcing air out of duct leaks and requiring the blowers to compensate for the added pressure. Essentially, blocking heating vents causes your furnace to work harder and longer than it is intended to work. Further, it forces air pressure to build up in your air ducts, which may both cause and worsens airflow leaks — particularly at joints and seams. Pros recommend keeping at least 80 percent of your heating registers open to prevent unnecessary air from building up in your furnace.
Here at Four Seasons Heating and Air Conditioning, we understand that the toughest aspects of winter weather can sometimes be too much for any furnace. That’s why we offer year-round, same-day furnace maintenance to ensure that your home and family never freeze. With no additional charge for after-hours service, you’ll soon discover that Four Seasons Heating and Air Conditioning is the affordable, expert service your home needs and deserves.

Lennox is another leading manufacturer and marketer of gas central furnaces. Lennox central furnaces are available in single and multistage configurations, with some models capable of an AFUE rating of more than 90 percent. Lennox markets units that meet Energy Star requirements and makes others that it claims offer quiet operation. The average price of a Lennox central gas furnace is about $2,500 and Lennoxes are sold through their dealer network.

Gas furnaces and heaters have control shutoffs to prevent gas leaks, but they are not fail-safe. If you smell gas in your house, do not turn any lights on or off, and do not try to shut off the gas leading to the furnace. Get out of the house, leaving the door open, and immediately call the gas company or the fire department to report a leak. Do not re-enter your home.

Let us take care of your water heater replacement in Federal Way, WA so that the job is done correctly the first time. We can make sure that your home has exactly what it needs for bountiful hot water. We offer a number of different makes and models to replace your old one, and we can ensure that it integrates seamlessly with the rest of your plumbing. Call Bob’s Heating & Air Conditioning today.
I really appreciated the great same-day service provided by Chris H, Swan Plumbing & Heating's technician today. I made an appointment to get an estimate on the water heater replacement, and expected to make another appointment for the installation. But Chris came prepared with all the equipment needed, and replaced our leaking water heater in a very efficient manner within about 2 hours.
We’ve earned a reputation across Portland and The Dalles for dedicated customer service.  Consistently maintaining an A+ rating from the Better Business Bureau, Sky Heating & Air Conditioning meets higher standards of excellence through the little, important details that add up to a job well done.  It starts with a friendly voice on the phone, and the immediate focus of our extensive resources on your requirements.  From there, you can count on timely arrival, organized project management, careful cleanup, competitive pricing, and exemplary performance in every aspect of service.  When you contact Sky Heating & Air Conditioning for HVAC service in The Dalles and Portland, OR, your project is always handled by a highly-trained professional, who will achieve your goals for efficiency, reliability, and sustainable home comfort.

If your heating system in Everett, WA is not working it is likely your furnace needs repair or service. At times the fix is simple, other times it is not. Our heating and furnace service technicians have years of experience working on furnaces like yours in Everett, WA. C.M. Heating has service vehicles on call that are fully equipped with the tools and parts necessary to get your furnace back up and operating.


Hello, We have a Hunter ceiling fan that no longer spins. It has power, as the light still works and when you push the remote you hear the clicking, like it's trying to engage, but the blades do not spin. Does this sound like a possible flywheel issue? I removed the Remote Receiver, part 85112-02, and apparently it's no longer available, but I don't think the receive is the problem. Any feedback would be welcome.
As a technical industry, the heating and cooling field is associated with annual advances. New energies make our industry an exciting place to work. Our team thrives on keeping up to date with all changes in the HVAC field. We are here to share our knowledge with each customer. When you are ready to update your HVAC system, we can help you select the ideal system for your home.
Professional air duct cleaning in Federal Way, WA is important because it ensures that your ductwork functions as it is supposed to. When dust and other debris accumulate inside your ducts, they can hinder airflow, which can raise your energy consumption and cause the cost of cooling to be much higher than should be the case. Let us keep your ducts in good working order.
Getting the most from your air conditioner means more than just adjusting the temperature so often. While today’s air conditioners are increasingly reliable and they often last for years upon years, they must be routinely taken care of by a professional air conditioning maintenance technician if they are to function as intended. With our air conditioning maintenance in Federal Way, WA, your system is in good hands.
If your furnace has a pilot light, look for the flame. Check your owner’s manual or the instructions posted inside the furnace cabinet for step-by-step lighting instructions. Usually this involves first turning the gas valve to Off and waiting a couple of minutes. Then you turn it to Pilot. Next, press and hold it down while you light the flame. Last, wait a minute or so, release it, and then turn it to On.

Yes. You should expect to pay a diagnostic fee to cover the cost of the technician's visit, the diagnosis of your air conditioner's problem, and a quote for the repair options. You will be advised of the issue along with recommended options to correct it, which may include a system replacement if your unit is old or significantly damaged. If you decide to replace the system, the diagnostic fee will be credited toward your replacement purchase.

Fitting a furnace with an electrostatic filter, which uses an electrical charge to help trap particles, or a high-efficiency particulate-arresting (HEPA) filter can reduce the amount of dust blown through the heating system. That might help people with asthma or other chronic lung diseases, but there's little evidence that other people need such filtration.
2Be sure the furnace’s circuit breaker is on or that its fuse has not blown. Check both the main electrical panel and any secondary subpanels that supply power to the unit. If the circuit has blown or tripped, reset the circuit breaker by flipping it all the way off and then on again. Or replace the fuse. If the circuit blows again, there is probably a short in the electrical system providing power to the furnace. For this, you may need to call an electrical contractor.
BGE HOME HVAC repair technicians are thoroughly trained and certified to work on all major brands of heating and air conditioning equipment. When your system breaks down and needs a heating and air conditioning repair, you want to call someone you can trust. Need air conditioning service in the middle of the night? Emergency heating and cooling HVAC service is available 24 hours a day by calling 888-243-4663.
We offer a number of indoor air quality products and services in Federal Way, WA, including air duct cleaning, air filtration systems and duct sealing. Keeping your ducts in good shape is a great way to prevent noxious particles from accumulating therein. A whole–house air filter is the best way to remove contaminants. Call Bob’s Heating & Air Conditioning today for more details.

Moncrief provides a wide range of services from high-quality energy-efficient systems, tune-ups and inspections, as well as repairs in the Roswell and Marietta areas. As a full-service heating and cooling company, we stay up-to-date on the most economical and energy-efficient systems available for your home or business. In addition, our technicians are well-trained in a wide range of systems to provide quality and cost-efficient furnace service, repairs and installation.
When your gas furnace isn’t blowing hot air, the issue could be due to a faulty pilot light or broken ignitor. Remove the furnace cover panel and visually inspect whether you can see a flame from the pilot light. A natural gas furnace will be blue and yellow in color, and a propane furnace should have a bluish green flame with a yellow tip. If you can see a flame and it appears normal, the issue could be related to the furnace blower motor or other complex furnace parts. If the flame appears low or non-existent, it’s best to contact an experienced furnace repair company. Remember to never touch any open wires; contact a professional.

Inspect your furnace thermostat by first making sure that it’s turned on. Also, ensure that the thermostat switch is turned to “heat” and not “cool”. If your furnace will still not start with the thermostat on, try adjusting the temperature settings to a few degrees higher. Inspect any visible wires for breaks or splits, and make sure your thermostat batteries are not dead. Do not touch any open wires; contact a professional.


A pinging or popping sound coming from the duct work can come from thermal expansion—the ductwork expanding and contracting as it heats and cools.  Or, air blowing past a loose flap of metal can make the sound. Track along the duct runs, listening for the sound. If you locate it, make a small dent in the sheet metal to provide a more rigid surface that’s less likely to move as it heats and cools.
Customer would like to have her furnace maintained before winter. She would also like her blower wheel and assembly cleaned. System was operational upon arrival. I checked the components within the unit and found the blower capacitor was out of specifications. It was replaced with new one. Blower assembly was pretty dirty. I cleaned the assembly. Burner assembly was ok, I cleaned flame rod. CO output was nominal. Heat output was also nominal. No other issues at this time.
Customer stated their blower fan is consistently running. She has had the furnace off all summer and just fired it up and it will just blow consistently. Upon investigation, the technician found that the damper control was sending 24V to G terminal while switched off. This indicates a stuck closed relay. I disconnected it and tested the unit. Due to age of unit, I would recommend upgrading to a more efficient model.
Rheem manufactures and markets gas central furnaces that are available in single and multistage configurations, with some models capable of an AFUE rating of more than 90 percent. Some units meet Energy Star requirements. The average price of a Rheem central gas furnace is about $2,300 and Rheems are sold through their dealer network. Rheem products are made by the same manufacturer as Ruud.
If you own a forced–air distribution system, then you need to ensure that you take care of your ductwork. After all, your central AC or heat pump is only as effective and efficient as the cleanliness and integrity of the ducts that transport your conditioned air. With our air duct cleaning service in Federal Way, WA, your HVAC system is in good hands.
Heat pumps that wring heat from outdoor air (and reverse the process in summer to act as an air conditioner) are inexpensive to install as an alternative to a cooling-only air-conditioning system. That makes them the preferred way to heat in the South and Southwest, where winters are typically short and mild. Heat pumps that wring heat from the ground are much more expensive to install, but they are suitable for cold climates because they can maintain their operating efficiency. Other inexpensive electric-heat options include strip heaters, which are installed in the ductwork of central air conditioning, and permanently installed baseboard units in each room. But before you consider any type of electric central heating in colder regions, keep in mind that electricity rates are much higher than those for natural gas and are likely to remain that way for the foreseeable future. You can get rate information for various fuels from local utilities and suppliers.
There is no debate.  Regular, professional maintenance of all types of heating equipment is absolutely essential to proper performance.  However, not all service is completed correctly.  The value of your investment is directly impacted by the skill and dedication of the contractor who handles seasonal service.  When you trust the experts from Air Blue Heating and Cooling Inc., you benefit from the best of the best.  Our technicians are fully licensed, bonded, insured, and by verifying their knowledge of today’s increasingly advanced heating and cooling systems, have achieved NATE-certification.  We are recognized as a Carrier Factory Authorized Dealer, a distinction that is earned through consistent demonstration of sound business practices, product knowledge, and technical proficiency.
We are open from 7am to 10pm every weekday and from 7am to 8pm on weekends. We book appointments in a 2 hour arrival window and call 30-45 mins before we arrive so you do not have to sit around waiting. It is often possible to schedule your appointment in the evening or morning hours to avoid conflicting with your work schedule. Are you looking for service today? Give us a call or click on one of the Schedule Service buttons found on the top and left sides of this page to contact us today.
×